Infrared IR Remote Control Controller For Arduino UNO R3 Nano Due MP3. Identification "ID" command can be used to find automatically that port which Fluke DMM was assigned to. 1X IR189USB 289 287 189 187 replace for FLUKE IR infrared data cable adapter. Reading a currently measured value is done by sending out Query Measurement "QM" command. Open a serial terminal program, for example, Hyperterminal in Windows, choose the port and setup parameters of the connection as 9600 baud, 8 bits, no parity, 1 stop bit.Check what port number was assigned for the Fluke multimeter: Start/M圜omputer/Properties/Hardware/Device Manager/Ports.Connect a Fluke 189/289 to a computer USB port.FTDI USB chip is used in the cable, a corresponding driver is available for downloading from here.
Install drivers for corresponding operating system.The detailed list of commands and parameters of the communication protocol can be found here. Nevertheless due to simplicity of the interface connection can be easily controlled from available in Windows HyperTerminal, for example, or from a simple custom program or script. Has to be mentioned that Fluke provides its own software to communicate with the DMMs: FlukeView Forms. While it is USB port physical connection it's represented as a serial COM port on operating system level. Fluke 189/289 needs Fluke IR189USB cable for that. That allows easily to setup communication with such a device and automate measurements. Supports Versiv firmware v6.5 build 5 or higher, and LinkIQ firmware v1.0 or higher. Contains security improvements required to work with LinkWare Live after 15 November 2021. Some of multimeters as Fluke 189 or 289, for instance, can be connected to a computer. LinkWare PC Software 11.2 (Standalone Install Version) Use this if installing on a PC that does not have Internet access.
0 kommentar(er)
